Products: Finnfoam

THERMAL INSULATION FOR EXTERIOR WALLS USING FINNFOAM The standard flat-edged or rebated FINNFOAM panels can be used to thermally insulate walls, but we also offer products that specifically designed for this application. As a FINNFOAM wall structure can be built without separate vapor barriers or wind-proofing, the material cost of construction is reduced. In addition,

ROOFS The leak-proof and highly insulating FINNFOAM allows  you to easily insulate your attic and save space in the process. The completely consistent cell structure of FINNFOAM means that separate wind-proofing or vapor barriers are not needed in the structure. Due to the strength of FINNFOAM, separate additional studs are not required under the roof

Pipe Trenches Pipe trenches and sewer pipelines are traditionally laid down at a frost-free depth to avoid freezing and frost damage. Deep pipeline trenches reaching below the groundwater surface may lead to the lowering of the groundwater surface, subsidence of streets, pipelines, and buildings in areas with softer soil, changes in vegetation in the area,

FROST PROTECTION INSTRUCTION FOR DECKS AND PAVING Summer is high season for building decks and paving yards. Paving begins with soil replacement, at which point you should ensure that the bearing capacity of the foundation soil that will provide the base for aggregate is sufficient, and make plans for the frost insulation. The foundation soil

ENSURE THE LONGEVITY OF YARD STRUCTURES The most important feature of frost protection is reliability, which refers to its resistance against long-term stress it will be subjected to in the ground. Frost insulation cannot compress or absorb water, as that would mean that it no longer functioned as designed. The importance and implementation of frost

FINNFOAM INFRA PANEL PROVIDES A PATENTED SOLUTION FOR PEDESTRIAN AND BICYCLE WAYS AND ROADWAYS RATED FOR LOWER SPEEDS At Finnfoam, we have explored the development potential of road structures with light traffic. The current founding methods are burdensome and expensive, and the results are rarely long-lasting if the subgrade has a low bearing capacity, which

SUPPLEMENTARY THERMAL INSULATION USING FINNFOAM INSULATION Supplementary thermal insulation can be implemented using standard rabbet edge FINNFOAM insulation panels or FF-PIR polyurethane insulation. If you want to minimize the increase in structural thickness, you can choose the 40 mm thick FF-PIR ALS renovation panels, which feature a 20 x 100 mm groove for batten strips at the edge.  Together

Insulating the Ceiling and Walls of an Older Attic When insulating older attics, the work typically consists of a two-stage process, because the spacing of timber frames may vary quite significantly. The current regulations require a U value of 0.09 in the roof and 0.17 in the walls. As the cell structure of FINNFOAM is completely